Dimplex VCX1525 Wartungshandbuch PDF herunterladen (Seite 9)

Remove glass assembly: 1.

Remove the screws securing the glass assembly on 2.

the bottom of the chassis (Figure 4).

Hold on to the glass assembly with both hands and lift 3.

the whole assembly straight up to remove (Figure 5).

Set glass assembly aside in an upright position so that 4.

the pebbles don’t fall out of the top opening.

Locate the socket and the wire harness at the top of 5.

the replace.

Remove the light bulb from the socket by turning it 6.

counter clockwise.

Unscrew the socket ring off the socket and remove the 7.

socket out of the socket mounting bracket.

Cut the wire harness at the 3rd wire tie on the top panel 8.

coming from the socket.

With pliers, squeeze the grommet that secures the 9.

socket as well as the short end of the cut wire harness

to the top panel, and pull the socket with the wire out of

the panel.

NOTE: If possible, wire ties should be left in place to

re-use on the new wire harness.

Insert the new wire harness into the opening down 10.

through the top panel.

Remove the socket ring off the new socket.. 11.

Insert the new socket into the socket mounting bracket 12.

and secure to the bracket by reconnecting the socket

ring.

Cut the new harness leaving approximately 8 inches 13.

of length to reach from the opening on the top panel

to just below the corner where the top meets the back

panel of the replace.

Feed the new wire harness through the wire ties, which 14.

secure the light harness to the top of the unit.

Connect the original wire harness still inside the re-15.

place to the new wire harness coming from the top by

stripping the ends approx. ¼ - ½ inch off each of the

4 wires. Connect the wires together with a wire-nut,

matching blue to blue; and white to white).

NOTE: You want minimal wiring hanging down from

the top, and the connection should be as close as possible

to the back corner in order to minimize the chance of the

connection being seen through the partially reective glass,

which will sit in front once unit is re-assembled.

Re-assembly in reverse order as shown above.16.

REMOTE CONTROL RECEIVER RE-

PLACEMENT

Tools Required: Philips head screwdriver

Needle Nose Pliers

Remove glass assembly: 1.

Remove the screws securing the glass assembly •

on the bottom of the chassis (Figure 4).

Hold on to the glass assembly with both hands •

and lift the whole assembly straight up to remove

(Figure 5).

Set glass assembly aside in an upright position so •

that the pebbles don’t fall out of the top opening.

With the unit facing up, remove the bottom panel by 2.

removing the screws around the outside of the panel

(11) and the 8 screws on the bottom. (Figure 7)

Figure 9

Top Light Dimmer

Thermostat

Heater On/Off Switch

3-Position Switch

Figure 7

Figure 8

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Kommentare zu diesen Handbüchern

Keine Kommentare

Dimplex VCX1525 Wartungshandbuch Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kamine Dimplex VCX1525