remote or receiver board be
replaced, you may need to
initialize the remote.
From a powered off state:
① Ensure power is supplied to
the replace through the main
service panel.
② Locate manual controls and
activate Main On/Off Switch
(Figure 8-A).
③ Press and hold the “ I ” button
(Figure 8-B) until all indicator
lights ash.
④ Press the ON button on the
remote control. The indicator
lights will ash rapidly then turn
off.
Remote Control Usage
The remote control operates the
replace levels sequentially (from
off): ames only; to ames and
low heat; to ames and high heat.
The level is increased every time
the ON button is pressed on the
remote control transmitter and the
replace can be turned off at any
point by pressing the OFF button.
Battery Replacement (Figure 9)
To replace the battery:
① Slide battery cover open on
the hand held transmitter.
② Install one (1) 12 Volt (A23)
battery in the battery holder.
③ Close the battery cover.
Operation
Maintenance
WARNING: Disconnect
power before attempting any
maintenance or cleaning to
reduce the risk of re, electric
shock or damage to persons.
Light Bulb Replacement
Turn unit off, allow at least ve
(5) minutes for light bulbs to cool
before touching bulbs to avoid
accidental burning of skin.
Light bulbs need to be replaced
when you notice a dark section
of the ame or when the clarity
Kommentare zu diesen Handbüchern