Dimplex VCX1525 Bedienungshandbuch PDF herunterladen (Seite 10)

10 www.dimplex.com

Fireplace Installation

Built-In Instructions

WARNING: The installation of

the replace unit must comply

with the applicable local and/or

national electrical codes and

utility requirements. This

installation should be

entrusted to duly qualied

personnel where required by

law.

① Leave the frame uninstalled

from the replace chassis until

step 13.

② Prepare a wall opening

following the dimensions shown in

Figure 4. Note that a 102 mm

minimum depth including the

thickness of dry wall is required.

Make sure there is enough

clearance for the cable coming

out from the bottom of the

replace.

!

NOTE: Where there are close

tolerances involved in wall

building or applications which

require a great degree of

precision, we recommend that

the product itself be used to

make the actual

measurements for the wall

opening. Dimplex will not be

responsible for inaccuracies in

the design or manufacture of

enclosures.

WARNING: Ensure method of

installation does not obscure

the air intake slots on top of

unit in any manner.

Keep a minimum of a 102 mm

clearance from top of unit to

any surface or material.

③ Wire a dedicated, properly

fused circuit with 240 Volt, 10

Amp rating. Allow up to 2.44 m

of service cable for connecting

power supply to junction box on

replace when installing after

nishing wall.

CAUTION: Use a two (2)

conductor, non-metallic sheath

cable with ground wire (three

(3) wires total) for the incoming

power supply on replace

inserts.

Figure 4

813

mm

362 mm

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare