Operation
The controls are located on the
right hand side of the replace
(Figure 8).
A. Main On/Off Switch
The Main On/Off Switch supplies
power to all replace functions.
B. Manual Selection Buttons
The Manual Selection Buttons
operate the replace's functions
manually.
Once the replace is switched
on, pressing the “ I ” button will
advance through the replace's
three levels of operation:
Level 1: The ame effect is turned
on and the rst indicator light
illuminates.
Level 2: The ame effect remains
on, the heater is activated to the
low heat setting, and the rst and
second indicator light illuminates.
Level 3: The ame effect remains
on, the heater is set to the high
heat setting, and all three (3)
indicator lights illuminate.
Pressing the “
” button at any
time will turn off the replace.
C. Indicator Lights
The Indicator Lights will illuminate
as the replace enters the various
levels of function.
D. Heater Thermostat Control
To adjust the temperature to your
individual requirements, turn the
thermostat control upward all the
way to turn on the heater. When
the room reaches the desired
temperature, turn the thermostat
knob downward until you hear
a click. Leave in this position to
maintain the room temperature at
this setting. For additional heat,
turn upward until you hear the click
again and the heater will turn on.
E. Top Light Dimmer Control
The top Top Light Dimmer Control
Figure 8
D
B
C
A
E
Kommentare zu diesen Handbüchern