Dimplex DF2000 Wartungshandbuch PDF herunterladen (Seite 7)

3-POSITION SWITCH REPLACEMENT

Tools Required: Phillips Head Screwdriver

Flat Head Screwdriver

CAUTION: If unit was operating prior to servicing allow

at least 10 minutes for lights, heating elements and top

panel to cool off to avoid accidental burning of skin.

WARNING: Disconnect power before attempting any

maintenance to reduce the risk of electric shock or damage

to persons.

1. Unplug the unit from power outlet.

2. Remove the rebox from the back of the mantel by

removing the retaining screws which secure the rebox

brackets to the mantel.

3. Remove the three screws along the back of the unit,

the two on either side along the top edge and the two

at the top of the glass retaining bracket on both sides.

(Figure 3)

4. Lay the Compact Fireplace on its back.

5. Gently open the top panel, laying it on the work sur-

face so that all of the components can easily be seen.

(Figure 4)

6. Locate the Main Power switch and disconnect the wir-

ing connections noting their original locations.

NOTE: A at head screwdriver can be used to gently

pry between the end of the connector and the switch to

release the wires.

7. Depress the retainer clips on the rear of the switch and

push the switch out through the opening.

8. Properly orient and insert the new switch and connect

all of the wiring.

9. Reassemble in the reverse order as above.

Figure 3

HEATER ON/OFF SWITCH

REPLACEMENT

Tools Required: Phillips Head Screwdriver

Flat Head Screwdriver

CAUTION: If unit was operating prior to servicing allow

at least 10 minutes for lights, heating elements and top

panel to cool off to avoid accidental burning of skin.

WARNING: Disconnect power before attempting any

maintenance to reduce the risk of electric shock or damage

to persons.

1. Unplug the unit from power outlet.

2. Remove the rebox from the back of the mantel by

removing the retaining screws which secure the rebox

brackets to the mantel.

3. Remove the three screws along the back of the unit,

the two on either side along the top edge and the two

at the top of the glass retaining bracket on both sides.

(Figure 3)

4. Lay the Compact Fireplace on its back.

5. Gently open the top panel, laying it on the work sur-

face so that all of the components can easily be seen.

(Figure 4)

6. Locate the Heat On/Off switch and disconnect the wir-

ing connections noting their original locations.

NOTE: A at head screwdriver can be used to gently

pry between the end of the connector and the switch to

release the wires.

7. Depress the retainer clips on the rear of the switch and

push the switch out through the opening.

8. Properly orient and insert the new switch and connect

all of the wiring.

9. Reassemble in the reverse order as above.

Figure 4

Top Panel

Glass Retaining

Bracket

Remote Control Receiver

3-Position Switch

Heater On/Off Switch

Thermostat

Heater

Assembly

Power Cord

1 2 3 4 5 6 7 8 9 10 11 12 13

Kommentare zu diesen Handbüchern

Keine Kommentare

Dimplex DF2000 Wartungshandbuch Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kamine Dimplex DF2000