Dimplex BFSL33 Installationsanleitung

Installation GuideModelBFSL33IMPORTANT SAFETY INFORMATION: Always read this manual rst before attempting to install or use this replace. For your sa

10www.dimplex.comSECTION D: ALTERNATE CONTROL OPTIONS120V MAIN POWER WALL SWITCH FIREPLACE JUNCTION BOX 120 V POWER SUPPLY (BREAKER PANEL) WHITE -

11Connect Ground (green) from the unit to the Ground (green) wire of the 9. main power wall switch by using a wire connector (not supplied).Connect L1

12www.dimplex.com! NOTE: Before installing the unit have the following wires installed:A 2 conductor wire with ground (3 wires total) from the power s

13power wall switch.Locate and separate by wire nut the 1 (red) and 2 (red). 11. Secure the 2 remaining Ground wires (green) with a ground screw in th

14www.dimplex.com CAUTION: The use of a wall switch to control the heater for a 240V instal-lation is not recommended. To control the heater remotely

15GL1 FROM UNITG FROMPOWER SUPPLYG FROM UNITL1 FROMPOWER SUPPLYNEUTRAL FROMUNIT AND SUPPLYUNITWIRE 1 FROMG FROM UNITWIRE 2 FROMG212 CONDUCTOR WIREUNIT

16www.dimplex.comunit.! NOTE: The following installation instructions are for a single pole thermo-stat.Loosen the screw securing the junction box and

17120V / 240V WALL MOUNTED FLAME OVERRIDE SWITCHDO NOT USE WITH NO HEAT INSTALLATIONS! NOTE: The replace can be wired to have a wall switch operate t

18www.dimplex.comUNITFROM FLAME OVERRIDE SWITCH21GL1 FROM UNITG FROMPOWER SUPPLYG FROM UNITL1 FROMPOWER SUPPLYNEUTRAL FROMUNIT AND SUPPLYUNITWIRE 3 FR

Dimplex North America Limited1367 Industrial RoadCambridge, ONCanada N1R 7G8© 2012 Dimplex North America LimitedUNIT INTERNAL WIRING DIAGRAMZZZFFT120V

2www.dimplex.comListing and Code Approvals ...3Model Specications. . . . . . . . . . . . . . . . . . . . . . . . . .

3The BF series replaces have been tested in accordance with the UL 2021 and CSA C22.2 No. 46 standards for xed and location-dedicated electric room

4www.dimplex.comFRAMING DIMENSIONSRough-In Framing DimensionsFirebox DimensionsRough-In Corner FramingThis replace is a zero clearance design. No com

5SECTION B: GENERAL ELECTRICAL INFORMATIONFor 120V installations • use two conductor, non-metallic sheath cable with ground wire (3 wires total) for

6www.dimplex.com! IMPORTANT: Ensure that the incoming power supply voltage matches the setting of the voltage selector switch.! NOTE: The voltage sele

7! IMPORTANT: The unit is factory congured for 208/240V operation.! NOTE: Use 3 conductor wires with ground (4 wires total) from the power supply (br

8www.dimplex.com! IMPORTANT: The unit is factory congured for 208/240V operation.! NOTE: Use 2 conductor wires with ground (3 wires total) from the p

9! IMPORTANT: The unit is factory congured for 208/240V operation.! NOTE: Use 2 conductor wires with ground (3 wires total) from the power supply (br