Dimplex VCX1525 Bedienungshandbuch PDF herunterladen (Seite 28)

14 www.dimplex.com

15

Operation

controls the brightness of the

top accent light that is used to

illuminate the pebbles.

Resetting the Temperature

Cutoff Switch

Should the heater overheat, an

automatic cut out will turn the

! replace off and it will not come

back on without being reset. It

can be reset by switching the

Main On/Off Switch to Off ( O )

and waiting ! ve (5) minutes

before switching the unit back on.

CAUTION: If you need to

continuously reset the heater,

disconnect power and call

customer service.

CAUTION: In order to avoid

a hazard due to inadvertent

resetting of the thermal cutout,

this appliance must not be

supplied through an external

switching device, such as a

timer, or connected to a circuit

that is regularly switched on

and off by the utility.

Remote Operation

The ! replace is supplied with a

radio frequency remote control.

This remote control has a range

of approximately 15 m. It does

not have to be pointed at the

! replace and can pass through

most obstacles (including walls).

The remote is supplied with one

of hundreds of independent

frequencies to prevent

interference with other units.

!

NOTE: Before attempting any

operation with the remote,

pull the plastic insulator strip

out from between the remote

casing and battery cover

(Figure 9).

remote or receiver board be

replaced, you may need to

initialize the remote.

From a powered off state:

① Ensure power is supplied to

the ! replace through the main

service panel.

② Locate manual controls and

activate Main On/Off Switch

(Figure 8-A).

③ Press and hold the  I  button

(Figure 8-B) until all indicator

lights " ash.

④ Press the ON button on the

remote control. The indicator

lights will " ash rapidly then turn

off.

Remote Initialization

Should your remote have dif! culty

communicating with the remote

receiver, or should either the

Remote Control Usage

The remote control operates the

! replace levels sequentially (from

off): " ames only; to " ames and

low heat; to " ames and high heat.

The level is increased every time

the ON button is pressed on the

remote control transmitter and the

! replace can be turned off at any

point by pressing the OFF button.

Battery Replacement (Figure 9)

To replace the battery:

① Slide battery cover open on

the hand held transmitter.

② Install one (1) 12 Volt (A23)

battery in the battery holder.

③ Close the battery cover.

Operation

Figure 9

On button

Battery

cover

Plastic

strip

Off button

Maintenance

WARNING: Disconnect

power before attempting any

maintenance or cleaning to

reduce the risk of ! re, electric

shock or damage to persons.

Light Bulb Replacement

Turn unit off, allow at least ! ve

(5) minutes for light bulbs to cool

before touching bulbs to avoid

accidental burning of skin.

Light bulbs need to be replaced

when you notice a dark section

of the " ame or when the clarity

1 2 ... 23 24 25 26 27 28 29 30 31

Kommentare zu diesen Handbüchern

Keine Kommentare