Dimplex VCX1525 Bedienungshandbuch PDF herunterladen (Seite 24)

6 www.dimplex.com

7

Fireplace Installation

!

NOTE: A 10 Amp, 240 Volt

circuit is required. A dedicated

circuit is preferred but not

essential in all cases. A

dedicated circuit will be

required if, after installation,

the circuit breaker trips or the

fuse blows on a regular basis

when the heater is operating.

Additional appliances on the

same circuit may exceed the

current rating of the circuit

breaker.

CAUTION: The heater must

not be located immediately

above or below a socket

outlet.

WARNING: Ensure the power

cord is not installed so that it is

pinched or against a sharp

edge and ensure that the

power cord is stored or

secured to avoid tripping or

snagging to reduce the risk of

! re, electric shock or injury to

persons.

Construction and electrical

outlet wiring must comply with

local building codes and other

applicable regulations to

reduce the risk of ! re, electric

shock and injury to persons.

Do not attempt to wire your

own new outlets or circuits. To

Quick Reference Guide

①

Before using the In-Stud

! replace verify:

 Are the circuit breakers for the

unit on?

 Are the light bulbs loose? (To

check, follow the instructions

for replacing the light bulbs

under the maintenance section

of this manual)

② The heater may emit a slight,

harmless odor when ! rst used.

This odor is a normal condition

caused by the initial heating of

internal heater parts.

③ The information regarding the

model of your unit can be found

on the model and serial number

plate located on the side of the

unit. See Page 3 for an illustration

on how to locate the rating plate.

reduce the risk of ! re, electric

shock or injury to persons,

always use a licensed

electrician.

WARNING: The Convex In-

Stud ! replace is wall

mountable and can be built in

a wall space 406 mm over-

center between 2 x 4 wall

studs. Follow the installation

instructions for either wall

mount or built-in mounting;

failure to do so may

cause damage or injury.

Wall Mounting Instructions

①

Leave the glass assembly

uninstalled until step 10.

② Select a location for the

! replace, preferably above an

electrical outlet and there must

be at least one wall stud behind

for the ! replace to mount onto.

The bottom of the unit must be

a minimum of 356 mm above

the " oor (mounting holes 0.75 m

minimum above the " oor)

(Figure 1).

Access to the electrical outlet

must be maintained. Ensure the

installation meets the national and

state/provincial electrical codes.

Fireplace Installation

!

NOTE: It is recommended

that the bottom of the unit not

be

mounted higher than

1.22 m from the ground to

maintain an optimized viewing

angle of the " ame.

CAUTION: The ! replace

must be mounted at two (2)

points, one of which must be

on a wall stud.

WARNING: High

temperatures may be

Figure 1

A

B C D E F G

H

0.75 - 1.92 m

0.36 - 1.22m

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31

Kommentare zu diesen Handbüchern

Keine Kommentare