Dimplex XLS6N Betriebsanleitung PDF herunterladen (Seite 2)

INSTALLATION INSTRUCTIONS

PREPARATION

The heater will arrive separately from its

storage bricks, 4 bricks will be required.

(2 Packs) Catalogue No. XT8300

Only heat resisting cable (min. rating T85) should be

used. The wires in the mains cable will be coloured as

follows:-

GREEN & YELLOW - EARTH

BLUE - NEUTRAL

BROWN - LIVE

SUGGESTED FIXINGS

SOLID BRICK/BLOCK: No. 10 Size plastic inserts,

8mm drill bit. Drill hole 15mm deeper than rawlplug

length.

PLASTERBOARD - If possible locate studding and use

No. 10 woodscrews directly into the wood, otherwise

M5 rawlplug intersets are suitable.

NOTE: FOR OTHER WALL TYPES (e.g. Timber frame

and hollow concrete) SEEK SPECIALIST ADVICE.

FIXING ASSEMBLY

ENSURE THAT FIXING KIT AND FEET HAVE BEEN

LOCATED BEFORE DISPOSING OF PACKAGING.

Fit the feet with the open end of the foot to the front of

the heater. Secure each foot using two taptite screws

provided in the ﬁ xing kit.

Place the heater on its feet and in the desired position

against the wall. Ensure the heater is based on a ﬁ rm

level surface at least 75mm from any end wall and at least

250mm below any shelf or similar projection. Cut away any

gripper rod or carpet which would prevent the heater sitting

ﬁ rmly on the ﬂ oor.

Mark the position of the two outside corners of the wall

bracket with the heater pushed tight against the wall.

Remove the wall bracket from the heater by removing

the screw at each end. Place the heater to one side and

reposition the bracket against the wall using the corner marks

for alignment.

Four ﬁ xing positions must be chosen for this heater. Mark the

positions for the ﬁ xing holes - one at each end. Remove the

bracket from the wall, drill the holes in the positions marked,

and insert suitable ﬁ xings previously described. Secure the

wall bracket to the wall.

If mains connection is to be made from the left side, at

this point the mains lead must be secured to the back of

the heater using ties provided in the ﬁ xing kit.

XLS6N MODEL ONLY - Attach the Room Sensor to the

plastic clip which is located at the rear of the of the heater,

as shown below.

WARNING - This appliance must be earthed

Room

Sensor

1 2 3 4

Kommentare zu diesen Handbüchern

Keine Kommentare

Dimplex XLS6N Betriebsanleitung Seite 2

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Raumheizungen Dimplex XLS6N