Dimplex CUH05B31T Bedienerhandbuch PDF herunterladen (Seite 6)

6 www.dimplex.com

Heater Installation

Figure 2

Figure 3

direction from center, and tilted in a

45 degree range while suspended

from the wall or ceiling.

!

NOTE: The hardware for

mounting the hanger bracket to the

wall or ceiling is not included.

CAUTION: When turning and/

or tilting the heater do not block the

exhaust opening.

The following steps are shown in

Figure 3:

Locate a stud or other suitable 1.

support and install hanger

bracket on wall or ceiling. Select

location so control knob on back

of heater can be reached easily. *

Insert carriage bolt into square 2.

opening of heater handle.

Slide spacer over the carriage 3.

bolt shaft and insert in hanger

bracket opening and hold them in

position.

Slide lock washer and thread 4.

nut onto carriage bolt, turn and

tighten with wrench.

* DO NOT INSTALL LESS THAN 6

FEET (1.9m) FROM THE FLOOR

ELECTRICAL CONNECTION

WARNING: Consult local electri-

cal codes in addition to the follow-

ing requirements

Turn off main power supply at the 1.

electrical panel.

Route supply wires from circuit 2.

breaker to an approved junction

box, located near compact unit

heater. These supply wires must

be two conductor non-metallic

sheath cable with ground wire.

Each heater should be on an

individual, properly fused circuit.

Route supply wires from junction 3.

box to CUH. These supply wires

must be two conductor metallic

sheath (BX) cable with ground

wire. Alternatively, appropriate

1 2 3 4 5 6 7 8 9

Kommentare zu diesen Handbüchern

Keine Kommentare