Dimplex DAC 9005 Spezifikationen PDF herunterladen (Seite 11)

Dehumidification.

NOTE!

The machine operates in the cooling mode but it does not lower the room

temperature. It absorbs the excessive humidity present in the air.

1. Plug the unit into a proper electrical outlet.

2. Position the exhaust tube as shown or remove

from the air-conditioner.

3.Turn the TIMER to position ON or 1 to 8

hours automatic timer setting.

4. Set the FAN SPEED control to the desired

output of airflow, high or low.

5. Set the THERMOSTAT to the maximum

cooling position.

6.When the water tank is full, the Full Water

indicator will illuminate and the compressor will

shut off automatically, the fan will stay on

circulating the air. At this time, you must empty the water tank as described in the

Drainage section.

Continuous Drainage.

In very humid conditions to avoid the unit from shutting down when the water tank is

full the unit can also be continuously drained if a convenient drainage position is

available.

Important!

The water is only gravity drained therefore the tube must lay lower and drain at a lower level

than the outlet tube at the rear of the air conditioner.

• Before operating the air conditioner, remove the water stopper, take out the rubber

plug and connect a PVC tube 12mm diameter.

Dimplex DAC12005_9005.qxd 7/5/05 3:34 PM Page 10

1 2 ... 6 7 8 9 10 11 12 13

Keine Kommentare

Dimplex DAC 9005 Spezifikationen Seite 11