Dimplex WRCPF-KIT Bedienungshandbuch

Owner’s ManualModel WRCPF-KIT7209110100R03IMPORTANT SAFETY INFORMATION: Always read this manual rst before attempting to install or use this device.

10 www.dimplex.com Wall Control Installation 1. Unpack the Wall Switch Remote Control and all hardware from its package.2. Release the Controller

11 Wall Control Installation Figure 12ControllerOuterHousingFigure 13Locking Screw Option (Figure 14)To prevent tampering, damage, and theft, it is

12 www.dimplex.com Wall Control Installation Figure 15Ensure each of the two Controller lead wires are connected to separate Low Voltage 24V~ only

13! NOTE: Wire leads are not polarized due to the nature of this device.9. Coil excess wiring to the back of the device box and insert the Control

14 www.dimplex.com Initialization After installation, locate the section which applies to your specic model of replace and follow the steps for r

15 Initialization DF3033ST and DFG3033 Models1. Ensure that power is supplied through main service panel.2. Ensure the Main On/Off Switch located

16 www.dimplex.com OperationA. On ButtonPressing this button toggles sequentially through the three levels of the replace. Pressing once activate

17 OperationWall Switch Remote Control135246 79118101213141. Room Temperature2. Set Temperature3. Flame Effect4. Purire™5. Heat Off Indicator

18 www.dimplex.com Operation1. Room Temperature Displays current ambient temperature in the room.2. Set Temperature Displays and controls the he

19 Operation7. RF Code Function and Change ProcedureIn the event that the Wall Switch Remote Control does not work properly with the receiver due

2 www.dimplex.com Table of Contents! NOTE: Procedures and techniques that are considered important enough to emphasize. CAUTION: Procedures and

20 www.dimplex.com WarrantyThis Dimplex Wall Switch Remote Control is warranted against defects in workmanship and materials for two years from date

3 Welcome & CongratulationsThank you and congratulations for choosing to purchase a Wall Switch Remote Control Kit from Dimplex, the world lea

4 www.dimplex.com Product OverviewThe Wall Switch Remote Control Kit is designed to work with the following Dimplex electric replaces:BF33STP • BF

5 Receiver Installation (BF units only) Open steel curtain (remove 1. glass doors if applicable). Remove two (2) screws on log 2. grate and remove

6 www.dimplex.com Locate the plastic 9-pin plug 6. in the bottom corner of the replace where the manual controls were plugged in to. Insert the plu

7 Wall Control Installation ! NOTE: All electrical wiring must comply with all national and local electrical codes and regulations. Always use a

8 www.dimplex.comFigure 5OuterHousingController2. Release the Controller from its Outer Housing by pushing the front face into the Outer Housing un

9 Wall Control Installation to complete the installation and to blend the installation in with your choice of decor. Hard Wired Power Supplied Ins