Dimplex EWM-SS Bedienungsanleitung

PRACTICAL USER’S GUIDE FOR THE ELECTRIC WALL MOUNTED FIREPLACE MODEL NUMBER: EWM-SS Valued Customer, We are pleased that y

RESETTING THE TEMPERATURE CUTOFF SWITCH Should the heater overheat, an automatic cut out will turn the heater off and it will not come back on without

MAINTENANCE WARNING Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons. LI

GLASS CLEANING The front glass is cleaned in the factory during the assembly operation. During shipment, installation, handling, etc., the front gla

TWO YEAR LIMITED WARRANTY Products to which this limited warranty applies This limited warranty applies to the following models of your newly purchas

What you must do to get service under this limited warranty Defects must be brought to the attention of Dimplex Technical Service by contacting Dimple

What Dimplex and its dealers and service agents are also not responsible for: IN NO EVENT WILL DIMPLEX, OR ITS DIRECTORS, OFFICERS, OR AGENTS, BE LIAB

CONTENTS PAGE 1 Important Instructions PAGE 2 Wall Mount Installation PAGE 6 Operation PAGE 7 Remote Operation PAGE 8 Maintenance

QUICK REFERENCE GUIDE FOR THE ELECTRIC WALL MOUNT FIREPLACE 1. Before using the electric wall mounted fireplace verify: • Are the circuit breakers

IMPORTANT INSTRUCTIONS RETAIN THIS USER’S GUIDE FOR FUTURE REFERENCE When using electrical appliances, basic precautions should always be followed t

NOTE A 15amp, 120 volt circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if

5. The wall-mounting bracket must be mounted to at least one wall stud (FIGURE 3) or into two wall studs (FIGURE 4) 6. When installing into two stu

4

UNIT INSTALLATION CORD SECURING (VIEW FROM BACK) 5

OPERATION The controls are located on the lower right side of the wall mounted electric fireplace. (FIGURE 7) A. MAIN ON/OFF SWITCH The switch ha