Dimplex BLF74 Wartungshandbuch

Service ManualModelBLF74UL Part Number6908740100 7400740000R00In keeping with our policy of continuous product development, we reserve the right to ma

10 www.dimplex.com2. Slide the controls assembly out toward the front of the unit. CAUTION: Ensure that the assembly is removed care-f

11FLICKER MOTOR/ FLICKER ROD REPLACEMENT WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of electric sh

12 www.dimplex.comguided and tucked into the proper openings along the right side so they are not pinched and allows enough space to reins

13they can both be easily reached. Holding both suction cup handles, tilt the glass forward and lift out. Carefully place the glass aside in a safe l

14 www.dimplex.com7. Remove the 2 screws, that secure the cover panel (Figure 13), located at the top of the mirror on the left side of t

15PROBLEM CAUSE SOLUTIONGeneralCircuit breaker trips or fuse blows when unit is turned onShort in unit wiring. Trace wiring in unit.Improper circuit c

16 www.dimplex.comPROBLEM CAUSE SOLUTIONHeaterHeater is not turning off Improper operation Refer to Operation SectionDefective Remote Swit

2 www.dimplex.comAlways use a qualied technician or service agency to repair this replace.! NOTE: Procedures and techniques that are c

3the replace off and it will not come back on without being reset. It can be reset by switching the On/Off Switch to Off and waiting ve minutes befo

4 www.dimplex.comMAINTENANCE WARNING: Disconnect power and allow heater to cool before attempting any maintenance or cleaning to reduce

5EXPLODED PARTS DIAGRAMREPLACEMENT PARTS LIST1261234141011781591. Element ... 2200510700RP2. Partially Reective Glass Kit ...

6 www.dimplex.comWIRING DIAGRAML1NL2432615RL3RL2RL1NNNL1120240COMMVOLTAGE SELECTOR SWITCHBLOWER MOTORHEATING ELEMENTHEATING ELEMENTFLAME M

7PREPARATION FOR SERVICE! NOTE: All components are replaceable from the front of the replace while the unit is mounted on the wall, with the excepti

8 www.dimplex.comwood ooring), it is recommended that a protective barrier be used underneath, (i.e. cloth, cardboard, thick plastic).5.

92. Slide the controls assembly out toward the front of the unit. CAUTION: Ensure that the assembly is removed care-fully, ensuring that no wires